GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||7 October 2012|
|PDF File Size:||8.19 Mb|
|ePub File Size:||10.6 Mb|
|Price:||Free* [*Free Regsitration Required]|
Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost. Forward Filter Manufacturers Co. The flow of water within the plane of a geotextile or geotextile-related product is aztm under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.
Products – BT Technology
I would like your verified suppliers matching service! Site Member 3 Years. Combining values from the two systems may result in non-conformance with the standard. D4176 Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. Your email address is incorrect!
Geotextile Water Xstm Capacity Tester, to determing the constant-head water flow capacity within aastm plane of a geotextile or geotextile-related product.
Please reply me widthin 24 hours. Send your message to this supplier. Please reply me within 24 hours. As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.
Comparative tests as directed in 5.
Recommended Quality Verified Suppliers. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Enter your email please. Competent statistical assistance is recommended for the investigation of bias.
Link to Active This link will always route to the current Active version of the standard. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated d47116 conditions.
Inquiry Sent Successfully Confirmation email has been sent: If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. Your message has been sent to the d471 suppliers.
ASTM D4716 Geotextile Water Permeability Tester
Historical Version s – view previous versions of standard. Your message must be betweencharacters! It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. For the best results, we recommend including the following details: Please enter 20 to characters to contact this supplier!
The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.